Instructions for the green breadboard
This is very similar to the instructions for the white breadboard
You will need:
A table tennis ball
One green breadboard
Wires
Soldering material
One LED with LED plastic holder
Three wire holder
One ESP32 development board
One 110 Ohm resistor
How to proceed:
Take the tennis ball, and make a hole in it, not too big, but sufficient to be able to mount the LED hold
Connect a wire at each end of the LED
Mount the LED holder into the hole of the tennis ball
Now, assemble the wire holder, with, at both ends one of the wire of the LED. Pay attention that the longer “foot” of the LED will be connected to the ground
Solder the wire holder on the breadboard
Take the ESP32 and look at the pin. Locate the pin number 27
Solder the two wire holders on the breadboard such that they can accommodate the dev board later
Solder a wire from the ground to the ground line of the breadboard
Solder the resistor at a free space of the breadboard
Solder a wire from the pin 27 of the processor to the resistor
Solder a wire from the resistor to the one side of the wire holder
Solder a wire from the ground pin of the dev board to the other side of the wire holder
Plug it in and test it with Thonny, see also Usage or continue reading